18
en
10. Disposal
Most of the materials from which Hilti electric tools are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for taking
back your old electric tools for recycling. Please ask your Hilti customer service department or Hilti representa-
tive for further information.
Should you wish to return the electric tool yourself to a disposal facility for recycling, proceed as follows:
Dismantle the electric tool as far as possible without the need for special tools. Use absorbent paper to wipe oily
parts clean and to collect any grease that runs out (total quantity approx. 50 ml). This paper should also be disposed
of correctly. On no account should oil or grease be allowed to enter the waste water system or to find its way
into the ground.
The individual parts should be separated as follows:
Part / assembly Main material Recycling
Toolbox Plastic Plastics recycling
Gear housing Plastic with magnesium alloy / brass parts Scrap metal
Bearing plate Magnesium alloy / brass Scrap metal
Grip, side handle Plastic Plastics recycling
Motor housing Plastic Plastics recycling
Fan Plastic Plastics recycling
Motor (rotor and stator) Steel and copper Scrap metal
Supply cord Copper, elastomer Scrap metal
Hammering mechanism parts Steel Scrap metal
Screws, small parts Steel Scrap metal
11. Warranty
Hilti warrants that the tool supplied is free of defects in
material and workmanship. This warranty is valid as long
as the tool is operated and handled correctly, cleaned
and serviced properly and in accordance with the Hilti
operating instructions, all warranty claims are made within
12 months (unless other mandatory national regulations
prescribe a longer minimum period) from the date of sale
(invoice date) and the technical system is maintained.
This means that only original Hilti consumables, com-
ponents and spare parts may be used in the tool.
This warranty provides the free-of-charge repair or replace-
ment of defective parts only. Parts requiring repair or
replacement as a result of normal wear and tear are not
covered by this warranty.
Additional claims are excluded, unless stringent
national rules prohibit such exclusion. In particular,
Hilti is not obligated for direct, indirect, incidental or
consequential damages, losses or expenses in con-
nection with, or by reason of, the use of, or inability to
use the tool for any purpose. Implied warranties of
merchantability or fitness for a particular purpose are
specifically excluded.
Send the tool and/or related parts immediately upon dis-
covery of a defect to the local Hilti marketing organisa-
tion for repair or replacement.
This constitutes Hilti’s entire obligation with regard to
warranty and supersedes all prior or contemporaneous
comments and oral or written agreements concerning
warranties.
To Next Page
Loading...
Need help?
General
