HIMA HIMax X-DI 32 02 - Redundant Connection via Two Base Plates

X-DI 32 02 4 Start-up
HI 801 017 E Rev. 4.00 Page 45 of 56
4.4.3 Redundant Connection via Two Base Plates
The figure shows the connection of one proximity switch or wire contact maker if the
redundant modules inserted in different base plates or are not located in the base plate
adjacently. The instrument shunts are placed on the field termination assembly.
System Cable X-CA 009 01 n
Proximity Switch Supply
Analog Measurement Processing
Figure 16: Redundant Connection via Two Base Plates