1.
2.
◆ Front Fork Maintenance
Always use a clean, oil-free lint-free cloth with plain or soapy water to clean your bike.
To prevent water from flowing into the front fork, you can turn the bike upside down.
Dry with a lint-free towel after washing. Pay specific attention to the inner tube and
the dust seal to reduce wear and prevent thinning of the inner tube, which can lead to
significant damage if the aluminum is exposed to air.
We recommend using a front fork dust cover to protect the inner tube of your front
fork. This prevents dust from entering as well as hard objects from hitting the inner
tube.
1.
2.
◆ Motor Maintenance (750W geared hub motor)
Please check your motor frequently and tighten any loose screws or nuts, to prevent
the vehicle from breaking down due to disconnected wires.
The geared hub motors are not waterproof, so avoid riding through water deeper than
the lower edge of the geared hub motor to avoid motor failure.
1.
2.
3.
◆ Chain Maintenance
We recommend cleaning the chain after each ride, especially in rainy and humid
environments. Use a dry cloth to wipe the chain and its accessories clean. Use a
brush to remove sand and dirt stuck in the chain, along with use warm soapy water if
needed. Do not use strong acidic or alkaline cleaning agents (such as rust remover),
because these chemicals can damage the chain.
Apply lubricating oil after cleaning to avoid rust. First, make sure the chain is dry, and
then apply the lubricating oil into the bearings.
To prevent unnecessary chain wear, try to maintain a vertical chain position when
shifting gears (do not use the smallest gear with the smallest flywheel, or the largest
gear with the largest flywheel, etc.).
Maintenance
1.
2.
3.
4.
◆ Battery Maintenance (48V 15AH Samsung/LG Lithium-ion battery)
Don't fully drain your battery. Turn off the power when the battery charge is low.
Fully charge the battery after each use, no matter how much power is used. This will
prolong the battery life. If the battery is not used for a long time, store the battery with
a full charge and charge it once a month.
The Himiway Bike can be safely ridden in light rain. However, riding through very
heavy downpours or through flooded streets is not recommended, as the crank
and/or motor can get wet, which may cause problems.
Keep the battery away from open flame or a high-temperature heat source. Do not
expose the battery to direct sunlight or recharge immediately after use in
high-temperature weather.
◆ Brake Maintenance
1.
2.
3.
4.
5.
Pad replacement:
The brake pads should be replaced if they have become contaminated or are less
than 1mm thick, or if the total thickness of the pad is less than 2.5mm.
Before riding:
Check the pads for wear or contamination.
Check the hose for cracking, wear or deformation. Replace if necessary.
Check if the brake system is operating correctly.
After riding:
Check the pads for wear or contamination.
Check the hose for cracking, wear or deformation. Replace if necessary.
Check if the brake system is operating correctly.
NOTICE: Do not touch the brake discs after heavy use.
At regular intervals:
Check the oil level in the reservoir.
Lubricate the brake lever pivot with grease.
Check to make sure that all the bolts are tightened to the correct torque
specifications.
Bleed The System
You should always bleed the system after you have shortened or replaced the hose
or have opened the system to the air at any time. Additionally, if the brake action feels
spongy, you may improve performance by re-bleeding the system.
25
To Next Page
Loading...
