Extra tools needed: (1)10mm Wrench (2)15mm Wrench
Bike Assembly Guide
◆ Preparation Checklist
NOTICE: Using an impact driver to achieve the required torque is not
recommended as it might cause damage. We suggest you use the wrench set we
provided and extra tools to manually adjust nuts and bolts.
Recommended Torque Values
Hardware
Handlebar *4
Stem *2
Upper Fork Crown *3
Lower Fork Crown *4
Fork Axle Pinch Bolt *4
Saddle *2
Seatpost Clamp *1
Front Axle *2
Rear Axle *1
Crank Arm Bolt *2
Pedal Axle *2
Rear Derailleur Pivot *1
Front & Rear Brake Adapter *4
Front & Rear Disk Bolts *12
Recommended Torque(N.M)
12
15
10
10
8
12-18
8
9-13.5
9-13.5
38-42
28-33
8-10
9-10
8-10
*Follow our Youtube channel Himiway Bikes to watch bike assembly tutorials！
Headlight
Pedals Hex wrench
Power cable
NOTICE:
1. Please keep the original packaging for at least 15 days!
2. Before assembling your bike, it’s recommended to remove the battery for the
reasons outlined below:
• Determine if there’s battery drain or damage during shipping.
• Reduce the weight of the ebike to make it easier to maneuver the bike while
assembling.
• Avoid battery damage during the assembly process.
Go to page 14 to learn about removing and charging the battery.
6
Transformer
Deraileur guard
To Next Page
Loading...
