Hioki 3286-20 - Data Hold Function HOLD; SLOW Mode; Recording Function REC

33
―――――――――――――――――――――――――――
Chapter 2 Measurement Procedure
――――――――――――――――――――――――
NOTE
2.6 Data Hold Function HOLD
2.7 SLOW Mode
2.8 Recording Function REC
This function freezes the counter at any desired
point for easy reading.
Press the
HOLD
key.
HOLD
annunciator lights on
the display and the digital display value is
maintained.
The data hold function is available for all
measurements.
To cancel the data hold function, press the
HOLD
key again.
If an indicated value fluctuates rapidly and is
difficult to read, you can select a slower display
update rate (about once every three seconds) to
make it easier to read the indicated value. Set
SLOW display by setting DISP in SETUP mode.
(See 2.9, "SETUP Function.")
SLOW mode is not available for harmonic
measurements.
The recording function can be used to display the
maximum value, the minimum value or the present
measured value.
1. REC annunciator will blink when you press the
MAX/MIN
key during a current or a voltage
measurement. This function will have stored the
measured data in the internal memory since the key
is pressed.
2. The auto power-off function is automatically
disabled. (
APS
annunciator is tuned off.)