Hope Electronics Technology Manual Edition V1.0 56
This function converts a resistance value to a length to display the length of
the measurement target (such as a conductor).
Press and hold the [TC/△T](LENGTH) key to display the ON/OFF setting
screen for the length conversion function.
Example: When the measured resistance is 8Ω and per meter resistance is
100mΩ/m
Measuring the Length of a Conductor (Length Conversion Function)
IMPORTANT
When length conversion function is set to ON, the comparator
△
cannot be turned ON. If T is set to ON, length conversion function
automatically turns OFF
To Next Page
Loading...
