Hioki CM4371 - Auto Hold Conditions

17
Manual Hold / Auto Hold
Auto hold conditions
Display value updates are stopped when the following two conditions are satised:
• When the measured value exceeds the threshold value described in the table in the next page.
(voltage, current)
When the measured value is less than the threshold value described in the table in the next page.
(resistance, continuity, diode)
• When the range over which the measured value is uctuating stabilizes within the uctuation range
described in the table in the next page.
Auto hold
e.g.: 100.0 A
Auto hold
e.g.: 99.0 A
Held
measured
value
Measured
value
Start
End
End
End
Fluctuation range
Fluctuation range
Fluctuation
range
Threshold value
e.g.: 12.0 A
Measurement
Start
Start
Time
If the measured value falls below the threshold value (voltage, current) or exceeds the threshold value
(resistance, continuity, diode) after display value updates are stopped, display value updates will stop once
more if the two conditions are satised again.