Hioki DT4200 Series - Accessories; Options

19
Durability
Drop proof Yes
Operating temperature and humidity*
1
-10°C to 50°C (DT4221, DT4222)
-10°C to 65°C (DT4223, DT4224)
Storage temperature and humidity*
2
-30°C to 60°C (DT4221, DT4222)
-30°C to 70°C (DT4223, DT4224)
Applicable standards Safety: EN61010, EMC; EN61326, Waterproof and dustproof: IP42
Safety
Maximum rated voltage between
input terminals and ground
CAT III 600 V, CAT IV 300 V
Maximum rated voltage between terminals Between the V and COM terminals: 600 V DC/AC
General Specications
TEST LEAD DT4911, Instruction Manual, LR03 Alkaline battery × 1,
Holster (attached to the instrument, with a test lead holder)
Accessories
Dimensions / Weight
*1. -10°C to 50°C(14°F to 122°F), Up to 40°C(104°F): at 80% RH or less (non-condensating),
40°C to 45°C (104°F to 113°F): at 60% RH or less (non-condensating),
45°C to 65°C (113°F to 122°F): at 50% RH or less (non-condensating)
*2. 80% RH or less (non-condensating)
72W × 149H × 38D mm (2.83″W × 5.87″H × 1.50″D),
190 g (6.7 oz.) (including batteries and holster)
Pocket
Models
Accessories / Options
*Z3210 set product
High-end models
Model no.
(order code)
DT4281 DT4282
Middle models
Model no.
(order code)
DT4261 DT4261-90*
Standard models
Model no.
(order code)
DT4252 DT4253 DT4254 DT4255 DT4256
Pocket models
Model no.
(order code)
DT4221 DT4222 DT4223 DT4224
DC 70 V
AC 33 V
CAT Ⅱ 600 V
CAT Ⅲ 300 V
50 mm
L9300 / L9207-10 / DT4911 Options (accessory)
DT4280/DT4250 Series
(Bundled accessory)
DT4220 Series
(Bundled accessory)
DT4261
(Bundled accessory)
TEST LEAD L9207-10TEST LEAD L9300
Cable length 90 cm (2.95 ft)
with one each red and black caps
Cable length 95 cm (3.12 ft)
Integrated cap and protective nger guard
with cap
Exposed tip metal pin: short
without cap
CAT III 1000 V, CAT IV 600 VCAT III 1000 V, CAT IV 600 V
CAT II 1000 VCAT II 1000 V
TEST LEAD DT4911
Cable length 54 cm (1.77 ft)
with one each red and black caps
with cap
without cap
CAT IV 300 V, CAT III 600 V
CAT II 600 V
Exposed tip metal pin: long
L9300, L4933 and L4934 probe
tips (at right) can be used on
L9207-10, DT4911 test leads.
CONTACT PIN SET L4933
SMALL ALLIGATOR CLIP SET L4934