Hioki DT4200 Series - Page 6

6
For electrical
work in the eld
For laboratory and
research use
DT4281 DT4282
Designed for maximum safety in the
eld when measuring current with
clamp-on sensors.
Designed for use in laboratories and
R&D applications where you wish to
measure a wide variety of parameters.
AC clamp-on measurement Frequency
Resistance Continuity check
Temperature Diode test
Capacitance Conductance
AC/DC automatic detection Voltage detection function
AC clamp-on measurement Frequency
Resistance Continuity check
Temperature Diode test
Capacitance Conductance
AC/DC automatic detection Voltage detection function
DC voltage 60.000 mV to 1000.0 V
AC voltage 60.000 mV to 1000.0 V
DC + AC voltage 6.000 V to 1000.0 V
DC current 600.00 μA to 600.00 mA
AC current 600.00 μA to 600.00 mA
DC voltage 60.000 mV to 1000.0 V
AC voltage 60.000 mV to 1000.0 V
DC + AC voltage 6.000 V to 1000.0 V
DC current 600.00 μA to 10.000 A
AC current 600.00 μA to 10.000 A
High-end models
Featuring high accuracy, extensive additional functionality,
and a broad range of measurement parameters
DC V typical accuracy: ±0.025% rdg. ±2 dgt.
Measurement categories: CAT III (1000 V), CAT IV (600 V)
Supported measurement parameter Supported measurement parameter (with model-specic variations) Unsupported measurement parameter
*The range gures given indicate the instrument’s measurement ranges (not the range of measurable values).