Hioki DT4261 - Introduction

DT4261 DIGITAL MULTIMETER Remote Operation Manual
P7/11
Command
Explanation
:FETCCNT?
:FETCCNT2?
Query measured count value.
Syntax :FETCCNT? [:FETCCNT2?]
Response <data×1>
<data> count value
Example; “3000”
:CALC:STAT:MAX?
Query measured maximum count value. (1)
Syntax :CALC:STAT:MAX?
Response <data×1>
<data> count value
Example; “5000”
:CALC:STAT:MIN?
Query measured minimum count value. (1)
Syntax :CALC:STAT:MIN?
Response <data×1>
<data> count value
Example; “2000”
:CALC:STAT:AVER?
Query measured average count value. (1)
Syntax :CALC:STAT: AVER?
Response <data×1>
<data> count value
Example; “3500”
:CALC:STAT:PEAK
MAX?
Query measured maximum peak count value. (1)
Syntax :CALC:STAT:PEAKMAX?
Response <data×1>
<data> count value
Example; “800”
:CALC:STAT:PEAK
MIN?
Query measured minimum peak count value. (1)
Syntax :CALC:STAT:PEAKMIN?
Response <data×1>
<data> count value
Example; “-800”
:SYST:APS
Set the APS.
Syntax :SYST:APS <data×1>
<data> “0” (off) or “1” (on)
Example; “:SYST:APS 1”
Response “OK” or “CMD ERR”
(1) Since the internal count value is returned, the value beyond the display range is not
guaranteed to be accurate.