Hioki DT4282 - Page 10

DT4281,DT4282 DIGITAL MULTIMETER Remote Operation Manual
P10/14
Command
Explanation
:SYST: CONDUCT
Set the threshold of continuity check.
Syntax :SYST: CONDUCT <data×1>
<data> Index of threshold “0”～“3”
Example; “:SYST: CONDUCT 1”
Response “OK” or “CMD ERR”
:SYST:DIODE
Set the threshold of diode test.
Syntax :SYST: DIODE <data×1>
<data> Index of threshold “0”～“6”
Example; “:SYST: DIODE 1”
Response “OK” or “CMD ERR”
:SYST:DBM
Set the standard impedance of dBm.
Syntax :SYST: DBM <data×1>
<data> Index of impedance “00”～“19”
Example; “:SYST: DBM 15”
Response “OK” or “CMD ERR”
:SYST:INIT
Put the meter to power-on-reset state.
Syntax :SYST: INIT
Response “OK”