Hioki DT4282 - 4 Summary of Commands

DT4281,DT4282 DIGITAL MULTIMETER Remote Operation Manual
P5/14
4. Summary of Commands
Table.3
Command
Parameter
Description
QPID
Query the Meter model.
*IDN
Query the Meter identification.
:SYST:RST
Put the meter to reset.
:SYST:LLO
Put the meter into the local lockout state.
:SYST:GTL
Put the meter into the local state.
:CONF?
Query the main function of the display.
:CONF2?
Query the sub function of the display.
:CONF
<function,range>
Configure the range.
:FETCCNT?
Query main measured count value.
:FETCCNT2?
Query sub measured count value.
:CALC:STAT:MAX?
Query measured maximum count value.
:CALC:STAT:MIN?
Query measured minimum count value.
:CALC:REL:OFFS?
Query the offset value of the relative. (main)
:CALC:REL:OFFS2?
Query the offset value of the relative. (sub)
:SYST:APS
<0|1>
Set the APS.
:SYST:BEEP
<0|1>
Set the action of the beeper.
:SYST:BLIT
<0|1>
Set the backlight.
:SYST:BATT?
Query the battery level.
:SYST:DEFA
Returns meter settings to their factory defaults.
:SYST:REL
<0|1>
Set the relative.
:STAT?
Query the status of the meter.
:CALC:PEAK:MAX?
Query measured peak maximum count value.
:CALC:PEAK:MIN?
Query measured peak minimum count value.
:SYST:FILTER
<0|1>
Set the filter.
:SYST:PEAK
<0|1>
Set the peak.
:SYST:SLOW
<0|1>
Set the average.
:SYST:CLEAR
Put the clear command.
:SYST:BLA
<0|1>
Set the auto backlight.
:SYST:CPER
<0|1>
Set the DC4-20mA or DC0-20mA.
:SYST:CONDUCT
<data>
Set the threshold of continuity check.
:SYST:DIODE
<data>
Set the threshold of diode test.
:SYST:DBM
<data>
Set the standard impedance of dBm.
:SYST:INIT
Put the meter to power-on-reset state.