Hirschmann EAGLE One - Ports and Interfaces Overview

24
Installation EAGLE One
Release 03 07/2014
1.5 Power supply
A 6-pin, screwable terminal block is available for the redundant supply to the
device.
For further information see “Working voltage” on page 6.
1.6 Ethernet ports
1.6.1 10/100 Mbit/s twisted pair port
The 10/100 Mbit/s twisted pair port offers you the ability to connect network
components according to the IEEE 802.3 10BASE-T/100BASE-TX standard.
This port supports:
 Autocrossing (if autonegotiation is activated)
 Autonegotiation
 Autopolarity
 10 Mbit/s half-duplex mode, 10 Mbit/s full duplex mode
 100 Mbit/s half-duplex mode, 100 Mbit/s full duplex mode
Delivery state: autonegotiation active
The socket housing is electrically connected with the front panel.
The pin assignment corresponds to MDI-X.
10b Terminal block connection
11 ACA21-USB interface
12 Label area for IP address of device
13 Button
(no function in the existing device version)
Pin Function
1 RD+ Receive path
2RD− Receive path
3 TD+ Transmission path
6TD− Transmission path
4,5,7,8 —
Table 6: Pin assignment of the 10/100 Mbit/ twisted pair port, RJ-45 socket, MDI-X
mode
Table 5: Front view (using the example Eagle-One-0200M2T1...........)
1
2
3
4
5
6
7
8