Hirschmann EAGLE One - Device Operation and Initial Wiring

Installation EAGLE One
Release 03 07/2014
33
 Signal contact (optional)
 Connect the wires according to the pin assignment on the device with
the clamps.
 Fasten the wires connected by tightening the terminal screws.
2.4.2 Wiring the digital input (optional)
 Remove the power connector from the device.
 Connect the wires according to the pin assignment on the device with the
clamps.
 Fasten the wires connected by tightening the terminal screws.
2.5 Operating the device
Note: The torque for tightening the working voltage terminal block on the
device is 4.5 lb-in (0.51 Nm).
The torque for tightening the terminal block on the digital input of the device
is 3 lb-in (0.34 Nm).
 Mount the terminal block for the operating voltage and the signal contact
using screws.
 Optional: Mount the terminal block for the digital input by screwing.
 Enable the working voltage.
Pin Signal, terminal Function
1 DI (+) Signal input
2DI (−) Reference potential
Table 10: Pin assignment: 2 pin, screwable terminal block (on the left), connection
to the device (to the right)
WARNING
ELECTRIC SHOCK
Connect only a working voltage that corresponds to the type plate of your
device.
Failure to follow these instructions can result in death, serious injury,
or equipment damage.
2
1