Hirschmann EAGLE One - Device Configuration; Initial Setup and Basic Settings; Firewall and VPN Functionality

Installation EAGLE One
Release 03 07/2014
35
3 Configuration
Note: Two or more devices configured with the same IP address can cause
unpredictable operation of your network.
Install and maintain a process that assigns a unique IP address to every
device in the network.
3.1 Making basic settings
In case of initial installation, enter the IP parameters. The device provides
multiple options for configuring IP addresses:
 Entry via V.24 connection
 Entry using the HiDiscovery protocol via the HiDiscovery or Industrial
HiVision application (via internal port)
 AutoConfiguration Adapter
 Web Interface
 SSH
Further information on the basic settings of the device can be found in the
“Configuration” user manual on the CD ROM.
 Default settings
 Ethernet ports: link status is not evaluated (signal contact)
 IP address: DHCP default setting off
Static IP address: 192.168.1.1/24
 Optical 100 Mbit/s ports: 100 Mbit/s full duplex
Other ports: autonegotiation
 Password for management:
user, password: public (read only)
admin, password: private (read/write)
 V.24 data rate: 9,600 Baud
3.2 Firewall and VPN functions
3.2.1 Firewall functions
The EAGLE One device supports the following firewall modes:
 Stateful Inspection Firewall
 Transparent Firewall