Installation EAGLE One
Release
03
07/2014
41
6Disassembly
Disconnect the data cables.
Disable the working voltage.
Disconnect the terminal blocks.
Disconnect the grounding.
To remove the device from the DIN rail, you proceed as follows:
Insert a screwdriver horizontally below the housing into the locking gate.
Pull the locking gate down without tilting the screwdriver.
Lift the bottom of the device away from the DIN rail.
WARNING
ELECTRIC SHOCK
Disconnect the grounding only after disconnecting all other cables.
Failure to follow these instructions can result in death, serious injury,
or equipment damage.
To Next Page
Loading...
