Hirschmann GREYHOUND GRS1042 - Page 33

Installation GREYHOUND Switch
Release 01 04/2016
33
 Switching LEDs
With device variants GRS 1142 the port status is displayed on the service
panel by default. You have the option of changing between the LED
displays using the command line interface (CLI). You require
administrator rights for this.
To change to the LED display on the port panel, execute the following
commands in the CLI:
To change to the LED display on the service panel, execute the following
commands in the CLI:
LED display Position on the device
Service panel Only device variants
GRS 1142
Port panel GRS 1042 and 1142
enable Change to the privileged EXEC mode.
configure Change to the configuration mode.
system port-led-mode
portpanel
Umschalten LED-Anzeige von Service-Panel auf
Port-Panel des Gerätes.
enable Change to the privileged EXEC mode.
configure Change to the configuration mode.
system port-led-mode
servicepanel
Umschalten LED-Anzeige von Port-Panel auf
Service-Panel.