Hirschmann GREYHOUND GRS1042 - Removing a Media Module; Removing an SFP Transceiver

56
Installation GREYHOUND Switch
Release 01 04/2016
6.2 Removing a media module
Proceed as follows:
 Loosen the screws in the front panel of the media module.
 Open the lock of the media module by pressing the locking lever outwards
(steps 1 and 2).
 Pull the media module out of the slot (step 3).
 Close the media module slot on the basic device using a cover panel.
 Fasten the cover panel using the 2 screws on the basic device.
The tightening torque is 4.4 lb-in (0.5 Nm).
6.3 Removing an SFP transceiver
Proceed as follows:
 Pull the SFP transceiver out of the slot by means of the opened lock.
 Close the SFP transceiver with the protective cap.
1
2
3
1
2