Hirschmann HC3901 - Page 26

23
Error
Code
Error Cause Elimination
E24
Upper limit value in
measuring channel
"force main boom
left" has been
exceeded.
 refer to E14  refer to E14
E25
Upper limit value in
measuring channel
"main boom angle
foot" has been
exceeded.
 refer to E15  refer to E15
E26
Upper limit value in
measuring channel
"luffing jib angle
foot" has been
exceeded.
 refer to E16  refer to E16
E27
Upper limit value in
measuring channel
"force luffing jib left"
has been exceeded.
 refer to E17  refer to E17
E28
Upper limit value in
measuring channel
"MB backstip
pressure " has been
exceeded.
 refer to E18  refer to E18
E29
Upper limit value in
measuring channel "
jib backstip pressure "
has been exceeded.
 refer to E19  refer to E19
E2B
Upper limit value in
measuring channel
"jib angle tip" has
been exceeded.
 refer to E1B  refer to E1B
E2C
Upper limit value in
measuring channel
"main boom angle tip"
has been exceeded.
 refer to E1C  refer to E1C
E2D
Upper limit value in
measuring channel
"super lift mast angle"
has been exceeded (if
avail.).
 refer to E1D  refer to E1D