Installation MACH102
Release
06
09/2014
5
Housing
Only technicians authorized by the manufacturer are permitted to open
the housing.
The device is grounded via the voltage supply socket.
Never insert sharp objects (small screwdrivers, wires, etc.) into the
inside of the device.
Verify that the electrical installation meets locally or nationally appli-
cable safety regulations.
Keep the ventilation slits free to ensure good air circulation.
Make sure there is at least 3.94 inches (10 cm) of space in front of the
ventilation slits of the housing.
Close all empty slots with a covering panel.
Mount the device horizontally or vertically, either as a desktop device,
in the switch cabinet (see figure 15) or on the wall (see figure 16).
If you are operating the device in a 19" switch cabinet: install
sliding/mounting rails for supporting the weight of the device.
Environment
The device may only be operated at the specified ambient temperatures
(temperature of the ambient air at a distance of up to 5 cm from the
device) and at the specified humidity.
Install the device in a location where the climatic limit values specified
in the technical data are not exceeded.
The device may only be used in environments with the pollution
degrees not exceeding the values specified in the technical data.
Qualification requirements for personnel
Qualified personnel as understood in this manual and the warning signs
are characterized by the following points:
The qualified personnel has received an appropriate training. His
training, knowledge, and experience constitute his qualification. This is
the prerequisite to connect, to ground and to label power circuits,
devices, and systems in accordance with current safety engineering
standards.
The qualified personnel are aware of the hazards associated with their
tasks.
The qualified personnel know proper measures against such hazards
to minimize the risk for themselves and for other persons.
The qualified personnel participate in regular further training.
Only trained service personnel are authorized to plug the
M1-8TP-RJ45 PoE media module into the basic device or remove from the
basic device.
To Next Page
Loading...
Need help?
General
