Installation MS20/MS30
Release
11
07/2013
45
2.12.4 100 Mbit/s F/O port
This port is an MTRJ, ST, or DSC socket.
The 100 Mbit/s F/O port offers you the ability to connect network components
according to the IEEE 802.3 100BASE-FX standard.
This port supports:
Full or half duplex mode
Default setting: Full duplex
Note: Make sure that the LH ports are connected exclusively with LH ports,
SM ports exclusively with SM ports, and MM ports exclusively with MM ports.
2.12.5 1000 Mbit/s F/O port
This port is an LC socket.
The 1000 Mbit/s F/O port offers you the ability to connect network
components according to the IEEE 802.3 100BASE-SX/1000BASE-LX
standard.
This port supports:
Autonegotiation
Full duplex mode
Delivery state: autonegotiation activated
Note: Make sure that you connect LH ports exclusively with LH ports, SX
ports exclusively with SX ports, and LX ports exclusively with LX ports.
1000 Mbit/s F/O ports (LC sockets) enable the connection of terminal devices
or independent network segments in compliance with the IEEE 802.3-2000
(ISO/IEC 8802-3:2000) 1000BASE-SX or 1000BASE-LX standards.
Connect the ports of the media modules plugged into the basic module as
required in order to set up your industrial Ethernet or expand your existing
network.
Install the data lines according to your requirements.
2.12.6 AUI port
The housing of the Sub-D plug is electrically isolated from the lower panel of
the device.
The AUI (Attachment Unit Interface) port offers you the opportunity to
connect a device via an AUI cable according to IEEE 802.3.
This port supports:
SQE test
DTE Power Monitor
Default setting: SQE test function and DTEPower monitor function is not
active.
To Next Page
Loading...
Need help?
General
