© 2005 PAT GmbH · D-76275 Ettlingen · Hertzstr. 32 - 34 · ++49 (0) 7243 709-0 · FAX ++49 (0) 7243 709-222 · Email: pat.ettlingen@pat-group.net 1
24 160 19_0106E_Rev D.doc / 2005-06-27 / rk.
CONTENTS
1. GENERAL INFORMATION......................................................2
2. WARNINGS .............................................................................2
3. SYSTEM DESCRIPTION.........................................................3
4. GENERAL TROUBLESHOOTING INFORMATION.................4
4.1 GENERAL FLOW CHARTS.............................................................. 5
5. ERROR CODES ......................................................................6
5.1 Operating Errors E01 through E05.................................................... 6
5.2 Lockout Function Errors 07 and 08 ................................................... 7
5.3 Analog Input Channel Errors............................................................. 7
5.3.1 Troubleshooting a Sensor Problem using the Display ...................... 8
5.3.2 Error Codes for the Analog Inputs..................................................... 9
5.4 Errors 31 and up ............................................................................. 11
6. FUNCTION LOCKOUT ..........................................................13
7. NO DISPLAY .........................................................................14
8. ANTI-TWO BLOCK PROBLEM .............................................16
9. LENGTH READING PROBLEM ............................................19
10. ANGLE READING PROBLEM...............................................21
11. LOAD READING PROBLEM .................................................23
12. DATA TRANSFER CENTRAL UNIT <--> CONSOLE............25
13. PROCEDURES......................................................................27
13.1 EPROM Location and Installation Procedure.................................. 27
13.2 Main Board Replacement Procedure .............................................. 28
13.3 Calibration of Sensors Procedure ................................................... 29
13.3.1 Pressure Transducer Calibration Procedure ................................... 29
13.3.2 Length Sensor Calibration Procedure ............................................. 30
13.3.3 Angle Sensor Calibration Procedure............................................... 31
13.4 Cable Reel LWG308/0001 Adjustment Procedure.......................... 32
13.5 Cable Reel Length Cable Replacement Procedure ........................ 33
14. TROUBLESHOOTING MOISTURE.......................................34
14.1.1 Water Ingress.................................................................................. 34
14.1.2 Condensation .................................................................................. 35
The information in this document is subject to change without notice. PAT makes no warranty of any kind with regard to this
material, including, but not limeted to the implied warranties of merchantability and fitness for a particular purpose. PAT shall
not be liable for errors contained herein or for incidental or consequential damages in connection with the furnishing, per-
formance, or use of this manual. This document contains proprietary information which is protected by copyright. All rights
reserved. No part of this document may be photocopied, reproduced, or translated to another language without the prior
written consent of PAT
To Next Page
Loading...
