Scanning for channels can take several minutes.
Note: You should plan to repeat the channel scan periodically to make sure you are receiving all
of the latest channels. Broadcasters add and remove channels, move channels to different parts
of the spectrum, and change the power levels of their channels periodically. You’ll also have to
repeat the channel scan if you remove the Antenna TV tile from the Home screen or perform a
factory reset. To repeat the channel scan at any time, go to Settings > TV inputs > Antenna TV >
Scan again for channels. Your antenna reception and picture quality depends on the position of
your antenna and on your location relative to the antennas of broadcasters in your area.
Now, you’re ready to watch broadcast TV! While you’re watching, try the following:
• Press UP or DOWN to change channels.
• Press LEFT to display the channel list and then use UP and DOWN to select a channel to watch.
Or press REWIND or FAST FORWARD to jump through the channel list a page at a time.
• Press OK to display information about the current program.
• Press to switch to the previously tuned channel.
• Press to see options for picture and sound settings.
“Hisense • Roku TV Remote control” on page 29
has more information on using the remote control
buttons while watching TV.
26
To Next Page
Loading...
Need help?
General
