28
FLUSH-MOUNT INSTALLATION INTO THE WORKTOP
Appliances without faceted edges or decorative frames are suitable for flush mounting.
brushed edge faceted edge decorative frame
1. Installing the appliance
The appliance may only be installed into a temperature- and water-resistant countertop,
such as a countertop made of (natural) stone (marble, granite), or solid wood (the edges
along the cut-out have to be sealed). When installing into a countertop made of ceramics,
wood, or glass, a wooden sub-frame should be used. The frame is not supplied with the
appliance.
The appliance may only be installed into a countertop made of other materials after
you have consulted the countertop manufacturer and obtained his express approval.
Internal dimension of the basic unit should be at least equal to the internal cutout for the
appliance. This will allow simple removal of the appliance from the countertop. Attach
sealing tape along the perimeter of the bottom of the glass panel.
First, feed the power cord through the cutout. Place the appliance over the centre of the
cutout.
Connect the appliance to the power mains (see instructions for connecting the appliance).
Before sealing the appliance, test its operation.
Seal the slot between the appliance and the countertop using a silicone sealant. The
silicone sealant used to seal the appliance has to be temperature-resistant (to at least 160
°C). Smooth out the silicone sealant using a suitable tool.
Observe the instructions for use of the selected silicone sealant. Do not switch on the
appliance until the silicone sealant has dried completely.
785072
To Next Page
Loading...
Need help?
General
Weight and Dimensions
