- 40 -
3、ISP_Tool connected failure
Close the SecureCRT, check whether “ ” in front of “UseSWI2C” of “Config” .
4、If ISP_Tool connected appear error “ Device not selected,yet”;
Reduce the I2C speed setting figure lower “Roughly speed” about “200KHz” and have a try.
5、After USB upgrade, appear “mtdoops: mtd device (mtddev=name/number) must be supplied，Kernel
panic - not syncing: VFS: Unable to mount root fs on unknown-block(179,4)”
Reason: After burn mboot and before USB upgrade, forget to clear the
zone schema.
Don’t burn mboot again，ONLY restart TV with “cu” demand to USB upgrading again
in mboot .
To Next Page
Loading...
Need help?
General