15
Certification and Compliance
FCC Notice
This device has been tested and found to comply with the limits for a Class B digital
device pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
device generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to the reception of a
radio or another television, which can be determined by turning this television off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
● If you are using an antenna to receive over-the-air television signals, reorient or
relocate the receiving antenna, increase the separation between the television and
receiver, and/or connect the television into an outlet on a circuit different from that to
which the receiver is connected.
● Tighten all connections between the television and other devices.
● Consult the dealer or an experienced radio/TV technician for help.
NOTE:
The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user’s
authority to operate the equipment.
The WiFi Module complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This device should be installed and operated with a
minimum distance of 20 centimeters between the radiator and your body.
Declaration of Conformity
Trade Name: Hisense
Model: 43A6GX/50A6GX
Responsible Party: Hisense USA Corporation
Address: 7310 McGinnis Ferry Road, Suwanee, GA 30024
Telephone Number: 678-318-9060
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
To Next Page
Loading...
