The programs for a single day are erased once completed (they are set to OFF). Those for 7 days remain
at AUTO for the following day.
Once the day and time have been set, the program has to be activated. To do this you have to place the
cursor over the “Activate” field and adjust it from OFF to AUTO by using passenger keys (16) and (17).
If you want to switch off a program, you simply go into the programmed pre-heater mode and change the
“Activate” field from AUTO to OFF.
The pre-heater program always operates as long as we are not in diagnostic mode.
The programmed pre-heater indication will appear on the screen when the batteries are switched off. On
the screen a hollow flame symbol appears with the number 1 (program 1) and/or a hollow flame with number 2
(program 2).
Pre-heater programmed screen.
If the pre-heater is operating because one of the programs switches it on, the flame of the corresponding
symbol is shown filled in.
Pre-heater screen operating in programmed mode.
NOTE: The pre-heater will not come on if the outside temperature is above 15ºC.
To Next Page
Loading...
