When OFF is selected and the bus is shut down, the system will remember OFF in the next starting. For
the system to work in AUTO mode again, it is required to go to the Preheater display and choose AUTO. As
information to the driver that OFF is selected, symbol is displayed in both Auto and Manual modes.
1.15. Inside temperature display.
By pressing key (10) the real inside temperatures in the driver’s and passengers’ areas are displayed.
Inside temperatures screen
After a few seconds, the screen returns to the display shown before pressing key (10).
1.16. Reheat option
When the system is in Climatization state, by pressing key , Demist function is displayed.
The following screen is displayed, in which Soft Demist is the preselected mode.
If not any key is pressed after few seconds, Soft Demist will be validated. It can also be validated by press-
ing the Demist key.
Bu pressing and in the driver área, options HARD and OFF can be chosen.
If, to enter to Demist, key is pressed for a while, HARD will be the preselected mode.
Once the chosen option is validated, one of the next two screens will be displayed.
To Next Page
Loading...