Screen with passenger climatization off
1.8. Adjusting the passenger unit selected temperature.
To adjust the desired temperature in the passengers’ area, press keys (16) and (17).
The selected temperature can be between 17ºC (63ºF) and 27ºC (82ºF).
The upper passenger unit temperature limit is HI and in this position the heating will operate at maximum
power continuously. The lower limit is LO and in this case the air conditioning will operate at maximum power
continuously.
1.9. Adjusting the speed of the passenger unit evaporator fans.
To adjust the speed of the evaporator fans, press passenger unit keys (13) and (14).
The selected speed can range from 1 to 5, with the following limitations:
If the engine is not running, no speed can be switched on.
If only the driver climatization unit is on and the compressor is switched on, speed 2 will automati-
cally be switched on in the passenger unit.
If the system is in any of the Demist modes (Soft or Hard), only speed 2 is possible, and that speed
can’t be manually changed.
If the compressor is operating the speed cannot be lower than 3.
When the speed of the evaporator fans is adjusted manually, the Manual screen will be displayed.
Manual screen (evaporator fans).
1.10. Adjusting the position of the passenger unit air recirculation
flaps.
If the passengers’ climatization is on, the position of recirculation flaps can be adjusted using passenger
unit key (11).The flaps will alternate between the positions for outside air (Renewal) and inside air (Recir-
culation), with the following limitations:
If you have pressed key (9), the recirculation flaps will be set to outside air. If the vehicle does not have
roof heating installed, the flaps will be in the inside air (recirculation) position if the temperature inside is more
than two degrees below the selected level. If the inside temperature does not exceed the selected temperature
minus 2ºC for more than 4 minutes, the flaps will automatically reset to the recirculation position.When you
adjust the position of the recirculation flaps manually the manual screen will be displayed.
To Next Page
Loading...