EasyManua.ls Logo

Hisun FORGE 110 - Tire Pressure and Wear Limits

Hisun FORGE 110
116 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Pre Operation Check List 5-6
Tire Pressure
The tires should be inflated to the recommended
pressures before each ride:
Front tires: 4psi0.28kgf/cm
2
, 28kpa
Rear tires: 7psi0.49kgf/cm
2
, 49kpa
Exceeding the recommended tire pressures
could result in tire failure. Fill tires slowly to
the required pressures.
Use a low pressure tire gauge (1)
Check tire pressure when tires are
completely cool.
Tire wear limit
Inspect tread wear
As shown in the figure below, replace tires
before tread thickness (a) becomes less
than .12in. (3mm)
a
Tread thickness

Related product manuals