EasyManua.ls Logo

Hisun HS500UTV - Replacing Headlight Bulb

Hisun HS500UTV
173 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Periodic Maintenance and Adjustment 8-43
Specified fuse:
Main fuse:
Headlight fuse:
Ignition fuse:
Auxiliary DC jack fuse:
Signaling system fuse:
Fuel system warmer fuse:
Four-wheel-drive motor
Fuse:
Backup fuse:
30.0A
15.0A
10.0A
10.0A
10.0A
10.0A
3.0A
10.0A
4. Turn the key to “ON” and turn on the
electrical circuit in question to check if
the device operates.
5. If the fuse immediately blows again, have
a service center check the electrical
system.
6. Install the battery compartment cover.
7. Close the hood.
WARNING
POTENTIAL HAZARD
Using an improper fuse
WHAT CAN HAPPEN
An improper fuse can cause damage to
the electrical system, which could lead to
a fire.
HOW TO AVOID THE HAZARD
A/ways use a fuse of the specified rating.
Never use a material in place of the
proper fuse.
Replacing a headlight bulb
If a headlight bulb bums out, replace it as
follows.
1. Lift the hood up.See pages 8-8-8-9 for
hood opening and closing procedures.
2. Remove the cover at the rear of the
headlight by pulling it off.

Table of Contents

Other manuals for Hisun HS500UTV

Related product manuals