4-7 Control Functions
Clock Mode
Pushing the
button switches the
display between the clock mode “CLOCK”
and the hour meter mode “HOUR” in the
following order:
CLOCK→HOUR→CLOCK
To Set the Clock
1. Set into the clock mode.
2. Press the watch button for 3-5 seconds.
3. Press the “KM/MILE” button to set the
hours.
4. Press the “TRIP/ODO” button to set the
minutes.
5. Press the watch button for 3-5 seconds,
and then release it, the clock will begin
to work.
Fault Codes Display of the Electronic
Injection System
When faults occur, the meter will display the
fault codes to guide the repair.
See attachment for faults code（page 11-1）
When the fault code is confirmed and has
been repaired, press the
button,
meter will go back to clock mode.
Fuel meter
The fuel meter will indicate the fuel volume.
As the fuel is running out, the indicator will
turn green into red, Vice versa.
To Next Page
Loading...
