Hitachi 3700 User Manual

•
•
•
I \IIIII IIIII IIIII IIIII IIIII IIIII ~~l,llllll~\~~~ IIIII IIIII IIIII IIIII IIIII Ill\ Ill\
311186 0023 23584
Hitachi 3700 CD Drive
Installation Instructions
Contents
Section
1.
Before You Begin
2.
Disconnect Cables and Remove System Unit Cover
3.
Install the CD Controller Board and Drive
1992 July
Page
2
2
3
3.1
Reset the OCLC 1/0 Board 's Synchronous Port Address
3
3.2
Install
the CD Controller Board
4
3.3
Install a Hitachi 3700 CD Drive in a Case
6
4.
Replace the System Unit Cover
7
5.
Attach the Cables and Power Cords 8
6.
Run Diagnostics
9
7.
Add SETVER to the CONFIG. SYS File
11
8.
Install the MS -DOS CD-ROM Extensions Software
12
9.
Reconfigure PASSPORT Software
14
10. Resolve Problems 14
10 .1
Dislodging a CD Caddy
14
10 .2
Resolving Other Basic Problems
15
11. Call
OCLC 16
These instructions tell you how to install the following CD-ROM prod-
ucts to use with your OCLC® workstation or other microcomputers:
• Hitachi ® CD controller board
• Hitachi 3 700 CD drive
Do not install the Hitachi 3 700 CD drive inside a workstation. Install
the Hitachi 3 700 CD drive in the external cabinet provided by OCLC.
(The first drive you purchase arrives installed in a custom cabinet .)
Be
careful to read and perform each step of these procedures. If you
damage the workstation or any upgrade components, you may be billed
for repairs . As you proceed with the installation, be especially careful
with the connector pins; use small jiggles and twists rather than force .
Bent or broken pins delay installation of the drive and increase your costs .
For additional information , see your workstation 's Installation and As-
sembl y Manual or the Instruction Manual provided with your CD drive.
If you have questions or need help, phone your OCLC-affiliated Regional
Network Office or OCLC User & Network Support at one of the follow-
ing toll- free numbers:
• 1-800-848- 5800 USA
• 1-800-848- 5878 Canada
• 1-614-793-8682 International and local (central Ohio)
Hitachi 3700 CD Drive Installation Instructions

Hitachi 3700 Specifications

General

Brand	Hitachi
Model	3700
Category	CD/CDR Drive
Language	English

Summary

1. Before You Begin

2. Disconnect Cables and Remove System Unit Cover

3. Install the CD Controller Board and Drive

3.1 Reset the OCLC I/O Board's Synchronous Port Address

Resets the OCLC I/O Board's synchronous port address for proper CD drive operation.

3.2 Install the CD Controller Board

Installs the Hitachi CD controller board into an expansion slot.

3.3 Install a Hitachi 3700 CD Drive in a Case

Installs the Hitachi 3700 CD drive into a dedicated case.

4. Replace the System Unit Cover

4. Replace the System Unit Cover

Replaces the computer's system unit cover after internal components are installed.

5. Attach the Cables and Power Cords

6. Run Diagnostics

7. Add SETVER to the CONFIG.SYS File

8. Install the MS-DOS CD-ROM Extensions Software

9. Reconfigure PASSPORT Software

10. Resolve Problems

10.1 Dislodging a CD Caddy

Provides steps to manually remove a CD caddy if it gets stuck in the drive.

10.2 Resolving Other Basic Problems

Offers solutions for common issues like cable connections, DIP switches, and error messages.

11. Call OCLC