Hitachi 3700 - 1. Before You Begin; 2. Disconnect Cables and Remove System Unit Cover

1. Before You Begin
Gather the proper tools before you begin :
• Small (No . 1) Phillips-head screwdriver
• Medium (No . 2) Phillips-head screwdriver
• Small flathead screwdriver
• Medium flathead screwdriver
• MS-DOS ® CD-ROM Extensions diskette and Installation Guide for
MS -DOS CD-ROM Extensions software
• MS -DOS 3.1 or later
• OCLC Check CD Program 3. 00 diskette
• PASSPORTR Software (working diskette or hard-drive copy) and the
PASSPORT Software User Guide
• Labels and a pen or pencil to label the cables
Before you remove your controller board from its package , ground your-
self by touching the metal portion of a table or chair , so you do not
transmit a static charge to the board or workstation .
As you unpack your controller board and CD drive, inspect them for ob-
vious defects or shipping damage. If either is damaged , call OCLC User
& Network Support to request a replacement .
2. Disconnect Cables and Remove System Unit Cover
2
1 Turn off the power to your workstation and unplug it.
2
3
4
5
If you do not turn off and unplug the workstation, you can electro-
cute yourself .
If you have a CD and/or CD drive case attached to your worksta-
tion , do not remove the cable that connects your CD drive and/or
CD drive case to your workstation until step 9 of this section .
Use the small flathead screwdriver to disconnect the monitor cable
and other cables as necessary . Label all of the cables as you discon-
nect them . This helps you properly reattach them .
Set the monitor, keyboard , and peripherals aside.
Follow the directions in your Workstation User Guide to remove
the sy stem unit cover . If you remove an y screws , be sure to set
them aside in a safe place . Avoid catching the cover on any wires
or c ables inside the unit. Set the cover aside.
• If y ou do not already have a CD drive case and/or CD drive
attached to your workstation , skip steps 6 through 10, and
continue from section 3 where you install the CD controller
board and drive .
• If you already have a CD drive case and/or CD drive attached
to your workstation, continue from step 6.
Hitachi 3700 CD Drive Installation Instructions
•
•
•