Hitachi C 10FCH2 Technical Data And Service Manual

--- 27 ---
11-3. Reassembly
Reassembly can be accomplished by following the disassembly procedures in reverse. However, special
attention should be given to the following items.
(1) Prior to reassembly, measure the insulation resistance of the armature, stator, switch and other electrical
components and confirm that the insulation resistance of each part is more than 5 M Ω.
(2) When replacing the Spring [10], apply 5 grams of Hitachi Motor Grease to the inner circumference of the new
Spring [10] prior to reassembly.
(3) When replacing Liner (A) [56] and Liner (C) [57], apply Hitachi Motor Grease to the sliding surface of the Base
Ass'y [67] prior to reassembly.
(4) When replacing Liner (B) [18], apply 5 grams of Hitachi Motor Grease to the sliding surface of the Turn Table
[36] prior to reassembly.
(5) Be careful not to pinch Liner (C) [57] when mounting the Turn Table [36] to the Base Ass'y [67].

Hitachi C 10FCH2 Specifications

General

Input power	1520 W
Power source	AC
Blade bore	30 mm
Blade diameter	255 mm
Idle speed (max)	5000 RPM
Sound power level	95 dB
Bevel setting (left)	45 °
Miter setting (left)	52 °
Sound pressure level	108 dB
Cutting capacity 45° miter	40 x 102 mm

Weight and Dimensions

Depth	628 mm
Width	460 mm
Height	561 mm
Weight	12000 g