10
English
○ Wear the harness as shown in the fi gure (if so
equipped). The blade turns counter-clockwise,
therefore, be advised to operate the unit from right
to left for effi cient cutting. Keep onlookers out of
working area at least 50 ft (15 m).
Fig. 15
Fig. 16
50 ft
(15m)
Fig. 17
WARNING
If cutting attachment should strike against
stones or other debris, stop the engine and
make sure that the attachment and related
parts are undamaged. When grass or vines
wrap around attachment, stop engine and
attachment and remove them.
Stopping (Fig. 18)
Decrease engine speed and run at an idle for a few
minutes, then turn off ignition switch (15).
15
OFF
Fig. 18
WARNING
A cutting attachment can injure while it
continues to spin after the engine is stopped
or power control is released. When the unit is
turned off , make sure the cutting attachment
has stopped before the unit is set down.
Semi-auto cutting head
○ When cutting, operate engine at over 6,500 min
-1
.
Extended time of use at low revolution may wear
out the clutch prematurely.
○ Cut grass from right to left.
WARNING
A cutting attachment can injure while it
continues to spin after the engine is stopped
or power control is released. When the unit is
turned off , make sure the cutting attachment
has stopped before the unit is set down.
MAINTENANCE
MAINTENANCE, REPLACEMENT OR REPAIR
OF THE EMISSION CONTROL DEVICES AND
SYSTEMS MAY BE PERFORMED BY ANY NON-
ROAD ENGINE REPAIR ESTABLISHMENT OR
INDIVIDUAL.
Carburetor adjustment (Fig. 19)
T-SCREW
Fig. 19
01EngCG24EKSUS.indd1001EngCG24EKSUS.indd10 2010/03/0410:54:522010/03/0410:54:52
To Next Page
Loading...
