Hitachi CP-WU5500 - Operating the Projector; PbyP;PinP Swap and Position Adjustment

50
Operating
Using ▲/▼ buttons on the remote control changes the size of main area in
PbyP mode.

Changing the size of main area in PbyP mode
1. Select INPUT MENU > PbyP / PinP SETUP > PinP POSITION (
67).
2. Using ▲/▼ buttons on the remote control changes the position of sub area
in PinP mode.
 Changing the position of sub area in PinP mode
main area
sub area
main area
sub area
PbyP (Picture by Picture) / PinP (Picture in Picture) (continued)
• For some signals, it may not be displayed correctly in the PbyP / PinP
mode, even if it can be displayed properly in the normal mode.
• PbyP/PinP is unavailable when MANUAL is selected in GEOMETRY
CORRECTION > EDGE BLENDING > MODE.
NOTE
Press the MY BUTTON assigned the PbyP / PinP SWAP (
84). The position of
the both area is exchanged without any setting change.

PbyP /PinP SWAP function
main
area
sub
area
main
area
sub
area
main area
sub area
main area
sub area
PbyP mode PinP mode
main area
sub area
main area
sub area
main area
sub area
main area
sub area sub area
main area