41
CP-WX11000 ( P6WX )
6-10 AUTO adjustment
Use of AUTO adjustment with the image through RGB input optimises V_POSI, H_POSI, and H_PHASE
automatically.
When a projected image has a dark tone around its periphery, AUTO operation sometimes makes arti-
facts in the image, shifts capture area and so on. These faults are caused by the period of image data not
being exactly distinguished from the period of blanking on signal processing.
To avoid such phenomena, AUTO function should be used with the full size picture that has bright tone
on its periphery.
Note
1) Faults displayed at the failure of AUTO adjustment depends on resolution of input source, scene
of picture etc.
2) There is no failure above in AUTO with video source through VIDEO, S-VIDEO or COMPONENT input.
The reason is that recognition of input signal’s standard does not need to search the capture range
from input signal itself.
Image when AUTO fails.
Noting image of top or bottom lines.
Shift of the image to East or West.
Artifacts on image. Etc.
Image when AUTO operates correctly
To Next Page
Loading...
