6
CP-WX11000 ( P6WX )
4. Adjustment
4-1 Before adjusting
4-1-1 Selection of adjustment
When any parts in the table 4-1 are changed, choose the approriate adjustment items using the chart.
Table 4-1: Relation between the replaced part and adjustment
Replaced part
Adjustment
Flicker
(Chap.4-2)
Ghost
(Chap.4-3)
PSIG
(Chap.4-4)
White
balance
(Chap.4-5)
Color
uniformity
(Chap.4-6)
Dichroic optics unit
²²²
UU
PO.Filter
²²²
UU
LCD/LENS prism assembly
|||||
Main Board
|||||
Lamp unit assembly
²²²
UU
: means need for adjustment. : means no need for adjustment.
: means recommended.
4-1-2 Setting of condition before adjustments
1. Before starting adjustments, warm up projector
for about 10 minutes.Turn off the automatic
keystone function in OPTION Menu. If you
changed [AUTO KEYSTONE] from [ON]
to
[OFF], set to [ON] after adjustment.
2. Set Zoom Wide to Max and project an image
with more than 1m (40 inches) in diagonal size.
3. Normalising the video adjustments
Press the [MENU] button to display the EASY
menu. If Advanced menu comes up, move to the
Easy menu.
Select the RESET in the EASY menu and press
the [
] or [ENTER] button to open the RESET dia-
log. Choose the EXECUTE with the [ ] button.
Note that the projector will not allow you to reset
its adjustment values with no signal input.
4. Perform all adjustments from the FACTORY
MENU. Operate as follows to display the FAC-
TORY MENU.
When using the remote control...
a. Press the [MENU] button of the remote con-
trol to display the Easy menu. (If the Ad-
vanced menu appears, move to the Easy
menu.)
b. Select the RESET in the Easy menu and
then press the [
] or [ENTER] button.
c. Next, press the [RESET] button once and
hold the [RESET] button for 3 seconds or lon-
ger (the FACTORY MENU will appear).
When using the keypad of the projector...
a. Press the
MENU
button of the projector to dis-
play the Easy menu. (If the Advanced menu
appears, move to the Easy menu.)
b. Select the RESET in the Easy menu and
then press the [
] or [ENTER] button.
c. Next, press the
[]
button once and re-
press and hold the
[ ]
button together with
the VIDEO button for 3 seconds or more (the
FACTORY MENU will appear).
To Next Page
Loading...
