21
Item Description
PROJECTOR
NAME
Any name can be set to the projector to identify it on the
network.
(1) Select the PROJECTOR
NAME and press the ►
button. The PROJECTOR
NAME dialog will be displayed.
Use displayed software keyboard to enter PROJECTOR
NAME.
DELETE : Deletes one character.
CLEAR ALL: Deletes all characters.
CANCEL : Goes back to network menu after discarding
the entered characters.
OK : Goes back to network menu after saving the entered
characters.
(2) The current PROJECTOR NAME will be displayed on the
first 3 lines. Particular projector name is pre-assigned by
default.
Use the ENTER or INPUT button to select and enter
characters.
To erase 1 character at one time, press the RESET button
or press the ◄ and INPUT button at the same time. Also if
you move the cursor to DELETE or CLEAR ALL on screen
and push the ENTER or INPUT button, 1 character or
all characters will be erased. Up to 64 characters can be
input for the PROJECTOR NAME.
(3) To change an already inserted
character, move the cursor
to one of the first 3 lines,
and move the cursor on the
character to be changed.
After pressing the ENTER or
INPUT button, the character is
selected. Then, follow the same
procedure as described at the
item (2) above.
(4) To finish entering text, move the cursor to the OK on
screen and press the ►, ENTER or INPUT button. To
revert to the previous PROJECTOR NAME without saving
changes, move the cursor to the CANCEL on screen and
press the ◄, ENTER or INPUT button.
2. Connection to the network
(continued on next page)
To Next Page
Loading...
