92
8.3 Event Scheduling
The scheduling function enables to setup scheduled events including power on /
power off. It enables to be “self-management” projector.
Note the following before setting the schedule.
• Schedule can also be set in SETUP - SCHEDULE menu of the
projector. (Refer to Operating Guide – SETUP).
• A maximum of 16 programs of schedule can be set. A maximum of 20 events
can be registered in 1 program.
• No events are registered in program 1 – 16 with factory default settings. The
program is required to be set in advance when using the schedule function for
the first time.
• The priority for scheduled events is as follows 1) specific date 2) weekly
• Up to five specific dates are available for scheduled events. Priority is given to
those with the lower numbers when more than one event has been scheduled
for the same date and time (e.g., ‘Specific date No. 1’ has priority over ‘Specific
date No. 2’ and so on.
• The power on event has the lowest priority among all the events that are set
at the same time.
• Be sure to set the date and time before enabling scheduled events. (
53)
• After the projector is moved, check the date and time set for the projector
before configuring the schedules.
•
The internal clock’s time may not remain accurate. Using SNTP is recommended
to maintain accurate time.
• Certain error state in the projector (such as temperature error, lamp error) will
prevent the projector from appropriate execution of scheduled functions/events.
• Events “My Image” and “Messenger” will not be executed appropriately and
result in “schedule execution error” status when the lamp does not light and/or
data to be displayed are not stored in the projector at the time when scheduled
event is executed.
• Events “Input Source” and “My Image” is not executed if security function is
enabled and the projector is locked due to the function.
NOTE
8. Other Functions
To Next Page
Loading...
