Item Description
MIRROR
Using the ▲/▼ buttons switches the mode for mirror status.
NORMAL
ó
H:INVERT
ó
V:INVERT
ó
H&V:INVERT
If the Transition Detector is on and MIRROR status is changed,
TRANSITION DETECTOR ON alarm (
50) will be displayed when
projector is restarted after the AC power is turned off.
STANDBY MODE
Using ▲/▼ buttons switches the standby mode setting between
NORMAL and SAVING.
NORMAL
ó
SAVING
• When SAVING is selected and the projector is in the standby
state, the power consumption is lowered with some functional
restrictions as below.
- The RS-232C communication control is disabled except turning
the projector on and changing the STANDBY MODE setting.
- The STANDBY of the MONITOR OUT (
below) is invalid, and no
signal is output from the MONITOR OUT port.
- The AUDIO OUT STANDBY of the AUDIO SOURCE (
36) is
invalid, and no signal is output from the AUDIO OUT ports (
15).
MONITOR OUT
The combination of a picture shown on screen and output from the
MONITOR OUT port can be arranged in the menu.
The picture coming into the port selected in the (2) is output to the
MONITOR OUT port while an image from the port chosen in the (1)
is on screen.
(1) Choose a picture input port using ▲/▼ buttons.
• Select STANDBY to specify the output from the MONITOR OUT
port in the standby state. This selection is available only when
NORMAL is selected for the STANDBY MODE (
above).
(2) Select one of the COMPUTER IN ports using ◄/► buttons.
Choosing the COMPUTER IN1 allows the following choice.
COMPUTER IN1
ó
OFF
Choosing the COMPUTER IN2 allows the following choice.
COMPUTER IN2
ó
OFF
Choosing other input or STANDBY allows the following choice.
COMPUTER IN1
ó
COMPUTER IN2
ó
OFF
• OFF disables the MONITOR OUT port.
• Initial settings for STANDBY are the following: COMPUTER IN1
when NORMAL is selected in STANDBY MODE; and OFF when
SAVING is selected in STANDBY MODE.
COMPUTER IN1
ó
COMPUTER IN2
STANDBY
COMPONENT
VIDEO
ó
S-VIDEO
ó
(Y, Cb/Pb, Cr/Pr)
To Next Page
Loading...
