Phenomenon Cases not involving a machine defect
Reference
page
Pictures appear
dark.
The brightness and/or contrast are adjusted to an
extremely low level.
Adjust the BRIGHTNESS and/or CONTRAST settings to a
higher level using the menu function.
26
The ECO MODE function is working.
Select the NORMAL for the ECO MODE item in the SETUP
menu.
34
The lamp is approaching the end of its product
lifetime.
Replace the lamp.
53, 54
Pictures appear
blurry.
Either the focus and/or horizontal phase settings are
not properly adjusted.
Adjust the focus using the focus ring, and/or the H PHASE
using the menu function.
18, 30
The lens is dirty or misty.
Clean the lens referring to the section “Caring for the lens”.
57
No signal is
output from the
MONITOR OUT
and AUDIO
OUT ports.
The SAVING function is working in the standby state.
Select the NORMAL for the STANDBY MODE item in the
SETUP menu.
35
RS-232C does
not work.
Troubleshooting
• Although bright spots or dark spots may appear on the screen, this
is a unique characteristic of liquid crystal displays, and it does not constitute or
imply a machine defect.
NOTE
Phenomena that may be easy to be mistaken for machine defects (continued)
To Next Page
Loading...
Need help?
General