44
CP-X2520 ( M2-25ED ) / CP-X3020 ( M2-30ED )
ATTENTION
· When the UPPER CASE is removed, the speaker will be taken off, too. Be sure to check the speaker,
and re-attach it in place if it.
· When you remove the BLANK BUTTON from the UPPER CASE, unhook the button carefully in order not
to break the claw of the UPPER CASE.
a. Tighten 7 screws on the bottom and 3 screws on the rear after attaching the upper case with the lamp
door separated.
In order not to make a gap between the upper and the bottom cases, tighten these screws while pressing
down the upper case in the direction of the arrow. Be careful not to bend the outside casing.(Torque:0.39-
0.59N•m)
When assembling
b. Attach the Lamp door.
CAUTION
This is not a screw hole. Do NOT insert
a screw or screwdriver into it to avoid
damaging the inside.
Lamp door
CAUTION
Tighten this screw using a manual
screwdriver.
M2.6x16 screw (2pcs)
M2.6x8 screw (1pc)
To Next Page
Loading...
