Hitachi CP-X4020 - SECURITY Menu; Ecurity Password Change

47
SECURITY menu
This projector is equipped with security functions.
From the SECURITY menu, items shown in the table
below can be performed.
To use SECURITY menu: User registration is required
before using the security functions.
Enter the SECURITY menu
1. Use the Ÿ/ź cursor buttons on the SECURITY menu to select ENTER PASSWORD and press the
Ź cursor (or the ENTER) button. The ENTER PASSWORD box will be displayed.
2. Use the Ÿ/ź/Ż/Ź cursor buttons to enter the registered password.
The factory default password is 1600. This password can be
changed (


below). Move the cursor to the right side of the
ENTER PASSWORD box and press the Ź cursor (or the ENTER)
button to display the SECURITY menu.
• It is strongly recommended the factory default password to be
changed as soon as possible.
• If an incorrect password is input, the ENTER PASSWORD box
will be displayed again. If incorrect password is input 3 times, the
projector will turn off. Afterwards the projector will turn off every time
an incorrect password is input.
3. Items shown in the table below can be performed.
If you have forgotten your password
(1) While the ENTER PASSWORD box is displayed, press and hold the
RESET (or press the Ż cursor and the INPUT buttons at the same
time) button for about 3 seconds.
(2) The 10 digit Inquiring Code will be displayed. Contact your dealer
with the 10 digit Inquiring Code. Your password will be sent after
your user registration information is confi rmed.
• If there is no key input for about 55 seconds while the Inquiring Code is displayed, the menu will
close. If necessary, repeat the process from (1).
Item Description
SECURITY
PASSWORD
CHANGE
(1) Use the Ÿ/ź cursor buttons on the
SECURITY menu to select SECURITY
PASSWORD CHANGE and press the Ź
cursor (or the ENTER) button to display the
ENTER NEW PASSWORD box.
(2) Use the Ÿ/ź/Ż/Ź cursor buttons to enter the new password.
(3) Move the cursor to the right side of the
ENTER NEW PASSWORD box and press the
Ź cursor (or the ENTER) button to display
the NEW PASSWORD AGAIN box, enter the
same password again.
(4)
Move the cursor to the right side of the NEW
PASSWORD AGAIN box and press the Ź
cursor
(or the ENTER) button and the NOTE
NEW PASSWORD box will be displayed for
about 30 seconds, please make note of the
password during this time.
Pressing the Ź cursor (or the ENTER) button will close the NOTE NEW
PASSWORD box.
• Please do not forget your password.
SECURITY menu
SECURITY menu
(continued on next page)