Hitachi CP-X4020 - Turning off the Power

11
ENGLISH
Turning off the power
1.
Press the STANDBY/ON button on the
projector or the remote control.
The message “Power off?” will appear on
the screen for about 5 seconds.
2.
Press the STANDBY/ON button again
while the message appears.
The projector lamp will go off, and the
POWER indicator will begin blinking in
orange. Then the POWER indicator will
stop blinking and light in steady orange
when the lamp cooling is complete.
3.
Attach the lens cover, after the POWER
indicator turns in steady orange.
Do not turn the projector on for about 10 minutes or more after turning it off.
Turning the projector on again too soon could shorten the lifetime of some
consumable parts of the projector.
VIDEO
DOC.CAMERA
KEYSTONE
ASPECT SEARCH
BLANK
MUTE
MY BUTTON
POSITION
12
ESC
ENTER
MENU
RESET
COMPUTER
MY SOURCE/
AUTO
MAGNIFY
PAGE
UP
VOLUME
DOWN
࡯
ON
OFF
㧗
FREEZE
SECURIT
Y
POWER
TEMP
LAMP
MENU
INPUT
STANDBY/ON
WARNING Ź'RQRWWRXFKDURXQGWKHODPSFRYHUDQGWKHH[KDXVWYHQWV
during use or just after use, since it is too hot.
Ź5HPRYHWKHSRZHUFRUGIRUFRPSOHWHVHSDUDWLRQ7KHSRZHURXWOHWVKRXOGEH
close to the projector and easily accessible.
NOTEPlease power off the projector after any connected devices are
powered off.
7KLVSURMHFWRUKDVWKH$8722))IXQFWLRQWKDWFDQPDNHWKHSURMHFWRUWXUQRII
DXWRPDWLFDOO\)RUPRUHLQIRUPDWLRQSOHDVHVHHWKH³2SHUDWLQJ*XLGH´LQWKH
CD.
STANDBY/ON button
POWER indicator