74
Troubleshooting
Phenomena that may be easy to be mistaken for machine defects (continued)
Phenomenon Cases not involving a machine defect
Reference
page
Sound does not
come out.
The signal cables are not correctly connected.
Correctly connect the audio cables.
9
The MUTE function is working.
Restore the sound pressing MUTE or VOLUME button on
the remote control.
1
7
The volume is adjusted to an extremely low level.
Adjust the volume to a higher level using the menu function
or the remote control.
1
7
The AUDIO/SPEAKER setting is not correct.
Correctly set the AUDIO/SPEAKER in SETUP menu.
36, 37
The audio on your HDMI equipment is not set to
Linear PCM.
The HDMI input on this projector supports Linear PCM audio
only. Check the audio setting on your HDMI equipment.
11
The audio on the HDMI input is muted.
Change the audio setting in the AUDIO menu.
37
The digital audio in HDMI signal does not work well.
Use the analogue audio, connecting either an RCA audio
cable or stereo mini cable.
9
No pictures are
displayed.
The lens cover is attached.
Remove the lens cover.
4, 16
The signal cables are not correctly connected.
Correctly connect the connection cables.
9
The brightness is adjusted to an extremely low level.
Adjust BRIGHTNESS to a higher level using the menu
function.
26, 27
The computer cannot detect the projector as a plug
and play monitor.
Make sure that the computer can detect a plug and play
monitor using another plug and play monitor.
11
The BLANK screen is displayed.
Press BLANK button on the remote control.
22
(Continued on next page)
To Next Page
Loading...
Need help?
General
