Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(RM)11-03-40]
(5) Removing and routing LAN cables
Routing before change
(VSP 5500 and VSP 5500H)
Routing after change
(VSP 5100 and VSP 5100H)
SSVP1
is not
installed
HSNBX-0
HSNBX-1
DKC-0
DKC-1
①
HSNBX-0
HSNBX-1
DKC-0
DKC-1
②
①
SSVP1
is installed
HSNBX-0
HSNBX-1
DKC-0
DKC-1
②
①
HSNBX-0
HSNBX-1
DKC-0
DKC-1
③
For SSVP1 is not installed
(a) Remove the LAN cable from the Management LAN port on the LAN board 1 in DKC-1, and
then connect to the Management LAN port on the LAN board 2 in DKC-1. ( ① )
(see (INST(IN)09-03-70))
(b) Connect the LAN cable between the Maintenance LAN port on the LAN board 1 in DKC-0
and the Maintenance LAN port on the LAN board 2 in DKC-1. ( ② )
(see (INST(IN)09-03-70))
For SSVP1 is installed
(a) Remove the LAN cable between the LAN port (U1) on SSVP1 and the Management LAN port
on the LAN board 2 in DKC-0. ( ① )
(b) Remove the LAN cable between the LAN port (U3) on SSVP0 and the Management LAN port
on the LAN board 1 in DKC-1. ( ② )
(c) Connect the LAN cable between the Maintenance LAN port on the LAN board 1 in DKC-0
and the Maintenance LAN port on the LAN board 2 in DKC-1. ( ③ )
(see (INST(IN)09-03-80))
(6) After removing and routing the LAN cables, click [Close] on the message window.
Rev.3
INST(RM)11-03-40
To Next Page
Loading...
