Hitachi DKC910I - 8 Removing SVP;SSVP

Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(RM)08-01-10]
8. Removing SVP/SSVP
NOTICE: This work takes about two hours. During the work, the Web Console cannot be used
for some time because of a rebooting of the SVP PC and verification.
Inform the customer of the following before starting the removal.
1. During the removal, customer cannot use Web Console/Storage Navigator via a
customer PC.
2. When SNMP is being used:
• ʻcold startʼ trap is reported several times.
• The obstacle trap which occurred during work may not be notified.
• SNMP command may not answer normally.
3. The following SIMs may occur during this work, just complete them when finished:
• bfe3a2 - Duplex SVP setup fail
• bf86a3 - SVP RAS Switch#1 remains
• 7󰀨2xx - Standby SVP fail
Rev.0.1
INST(RM)08-01-10