Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(RM)08-01-20]
Rev.0.1
INST(RM)08-01-20
1. Status of the SVP-OPTION
(1) Check statuses of the LEDs on the SSVP.
When they are in the statuses
, start operation from Procedure 2, “2. Operating the Additional
SVP”.
When they are in the statuses
, start operation from Procedure 3, “3. De-Installation Procedure of
Service Processor”.
Figure 8-1 LED Statuses on SSVP
HSNBX-1
HSNBX-0
SSVP1
SSVP0
Front view of HSNBX
SVP STATUS LED
Front view of SSVP
LED Statuses
A combination of LED statuses shown when the SVP-OPTION is operating as a Master SVP.
LED Statuses
A combination of LED statuses shown when the SVP-OPTION is operating as a Standby SVP.
SSVP0 (SVP-BASIC)
SSVP0 (SVP-BASIC)
SSVP1 (SVP-OPTION)
SSVP1 (SVP-OPTION)
lighting
lighting
lighting
lighting
To Next Page
Loading...
